We are going to show you how to draw a simple floor plan in CAD. We will use BabaCAD Home Edition CAD software, version 2020. Download link is below.įirst, draw a rectangle object, with 6 meters width and 5 meters height. Type character (‘monkey’ or ‘at’ email symbol), to specify that we are entering relative or offset coordinates. We will type then type ’6′, then ‘comma’, then type ’5′, and click enter to finish rectangle command. I will make a floor plan with a hall, one dining room,kitchen and toilet. It should fit to overall floor dimension of 6 times 5 meters. To draw room space, I will use line object. Click on the line command, and then specify desired length.Įnter the value, 4, then at 90 degrees, enter value of 3, so we will have living room sized 4 times 3 meters. I will draw and other lines to finish wall paths. Then, we can check the size of every room, and as we can see, we have living room of size 4 times 3 meters. Then, kitchen has size of 2 times 3 meters, and later we will also draw a toilet with the length of 2.5 meters.Īfter we finished this, now we can use offset command, to draw walls.īut, before starting with offset, we will first join specific lines, so we can later use offset command to draw a walls. To join lines, select two lines and use join command, and lines will be joined. We must draw some lines again, following existing lines, and using snap on end-point feature. Then, repeat join command again, and join lines which are left. We need a toilet, so I will choose a length of 2.5 meters. I have to draw a line with length of 0.5 using line command.Īfter that, start line and connect with the wall down below, using orthogonal snap feature.Įrase lines that are not needed. Just select, and type erase, or click on erase button in the menu. We will get the space for the toilet, which size is 3 meters in width and 2.5 meters in length. So, we’ve drawn basic stuff, and as you can see, it already getting some nice look of CAD floor plan. There are few lines to join, as we need them joined to draw the walls. Just select two lines, and type join command to join the lines. If some line or other object can’t be selected, just modify objects draw order, using command, send to back.Īfter we join all these lines, we will have separate poly lines, and then I will show you how to use offset command, to draw walls with specific width. We have prepared everything to switch to the next step. That next step is drawing of walls, using offset command.Ĭommand, offset, can be started by typing offset, in the command line, or by clicking on the menu button.Īfter we started offset command, we need to type offset value in the command line, and press the enter key.Īfter specifying offset value, we need to select the poly line object from which the offset line will be drawn.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |